SHOW output not working as expected
Posted: Sun Sep 23, 2018 4:13 pm
HI!
I'm using E1.31 output to control my lights. I have a generic RGB light which I have set up and can control on the simple desk. I get real time control and everything works as expected.
However when I start creating a show output set to a song I seem to be running into a glitch. Firstly the output is messed up. I'm just trying to have the light turn on and stay Red for 2 seconds then blue for 2 seconds to get a base line test. But when I play the output the light just flicks super briefly. It is the correct colour but isn't staying on. Second to this it is triggering about a second or more after it should in terms of the music sync.
Would be very grateful if you have any suggestions of where to start to investigate this?
Thanks!!
Tyson
I'm using E1.31 output to control my lights. I have a generic RGB light which I have set up and can control on the simple desk. I get real time control and everything works as expected.
However when I start creating a show output set to a song I seem to be running into a glitch. Firstly the output is messed up. I'm just trying to have the light turn on and stay Red for 2 seconds then blue for 2 seconds to get a base line test. But when I play the output the light just flicks super briefly. It is the correct colour but isn't staying on. Second to this it is triggering about a second or more after it should in terms of the music sync.
Would be very grateful if you have any suggestions of where to start to investigate this?
Thanks!!
Tyson