Q Light Controller+

Hi,

Is it possible to add multiple chasers to a cue list? That is after I have added a chaser to the cue list is it possible to add a second chaser that would follow the first one in the cue list?

Also, it it possible to set up to run a multi-head light bar AND a moving head at the same time using a cue list?

I can run the two lights by using a show and that works well, but I was looking for an easy way to have the two lights both running at the same time in a loop for some performances without having to set up a full show.

Is this possible, and what is the best way to do it with QLC+?

Thanks,
Burt

Replying to my own question.

Not sure if it is the best/proper way to do what I was trying to do but I found the following:

I can have two cue lists running at the same time, haven't tested with the mover connected yet but that might work.

But the other thing I found was that I could add my simple test show to a chaser, and set the duration to match the show length.

Then when I run the cue list the show runs and then restarts as I was wanting to do, so that definitely should run the light bar and the mover as it does when the show is running from the show tab.

Add the chasers you want to run in parallel to collections, add the collections to the cue list?