Q Light Controller+

Hi,

so the fixture validator has two problems:

- physical dimensions are missing, but i dont know what else to put there.
- invalid power consumption, but i dont know why 92W are invalid.


regards

Habefaro

Hey there! If you double click on any Channel in the fixture editor you get a new window with three tabs. On the physical tab you can enter the measurements of your device, its power consumption and other stuff. The Measurements are in your pdf, i highlightet them for you. You should try to enter your power consumption and your measurements there:) (As far as I understood, just did a few fixtures until now^°)

Ah I sse. I used the new fixture editor that comes with the git version. And there is an option on every mode to "use global settings" and you dont have to copy and paste it to every mode.

No Errors =)

Fixed and added:
- all 16 bit channels were wrong
- heads were wrong (and useless)
- modes should use global physical
- removed duplicated 8bit channels
- properly used aliases instead of 4 modes