Page 1 of 1
QTX PL-COB6Q
Posted: Mon Jul 09, 2018 7:46 pm
by RedDog
Hi,
I am very new to this world of lights... And even newer to QLC+.
So, though I kind of get how to input fixture details , I am little lost. If anyone has ready made fixture definition for QTX PL-COB6Q I would be very grateful, and I could see how to input for future.
Thanks,
RedDog
Re: QTX PL-COB6Q
Posted: Tue Jul 10, 2018 10:33 pm
by RedDog
Sorted, thanks to the excellent tutorials from Massimo Callegari... I eventually figured out what I was doing wrong.
Now have the fixture definition bit done... Onwards to light how. Excellent piece of software.. UI is a little off putting in it's PC ness, but it works.
Re: QTX PL-COB6Q
Posted: Wed Jul 11, 2018 8:11 am
by GGGss
Keith,
Welcome to this forum.
You may share your definition file, you know?
Re: QTX PL-COB6Q
Posted: Fri Jul 13, 2018 8:31 am
by RedDog
Not quite sure how to do that...
thnks for the welcome.
RedDog
Re: QTX PL-COB6Q
Posted: Sun Jul 15, 2018 9:49 am
by edogawa
Well there's another sub-forum here, called "Fixture definitions" right near the top... it has a sticky topic with guidelines for fixture submission.
basically, what you would do is: after running it through the online fixture validator
http://www.qlcplus.org/fixture_validator.php, correct any errors it mocks about, then just announce it in that forum and append your definition file as an attachment and optionally a link to the manual.
HTH, Edgar