Page 1 of 1
Could not create the egl surface: error
Posted: Fri Jun 22, 2018 1:58 am
by Yarjm
Hi
I have just installed version 20180410 (4.11.2) on raspberrian stretch.
I get the following error when running qlcplus:
Could not create the egl surface: error = 0x300b
Aborted
Any suggestions?
Re: Could not create the egl surface: error
Posted: Sun Jun 24, 2018 3:11 pm
by mcallegari
Hi, are you using my image or installed the deb package on a vanilla Stretch ?
this might interest you:
http://www.qlcplus.org/forum/viewtopic.php?f=17&t=12122
Re: Could not create the egl surface: error
Posted: Sun Jun 24, 2018 8:49 pm
by Yarjm
Hi mcallegari
The deb package.
I checked the manual installation from a previous version and made sure all the libraries it required were installed. I can't see any missing.
If this is part of the problem with the graphics driver then I will wait patiently and see what happens. I can use the image in the meantime. It is just handy to edit fixtures on the same box.
I love the program by the way.
Ray