Q Light Controller+

Hi,

I would be happy to get some support here, because I don't see the solution to my problem.

Is it possible to send the same values from the same universe to two outputs? The reason I want to do that is to control my fixtures simultaneously to the visualization program "Capture Argo".

Capture runs on the same machine and will be controlled by Artnet, while the lights are controlled by DMX.

I have an eDMX-2 by DMXKing and everything works fine as long as I choose the Artnet or the DMX for output.

Is there a chance to get my lights and the visualization controlled at the same time? Maybe the passthrough plugin is the key?

I would be grateful for hints and tips.

Regards
Jürgen

Hi, no solution on QLC+ 4 at the moment.
However, this feature has already been implemented in QLC+ 5.
See update video 2.1 http://www.qlcplus.org/forum/viewtopic.php?f=17&t=10682

I made a quick test setting up Universe 1 output to artnet connected Capture Argo to this. Universe 2 input to artnet, check passthrough and set output to ola, you can change ola to DMX. I'll test later setting universe 2 output to dmx and test it.