Q Light Controller+

I have just used the image I got from donating to install QLC+ on a rpi3.

I have a simple project. The virtual console as a time widget that runs a script at 17:15, it starts a sequence, waits 5hr15min and then stops the sequence. This works fine on a PC. However on the rpi the time doesn't display. I am not on site so can't test if its just a display issue or it will not start the script on time.

If I login to the rpi and issue a "date" command the correct time displays.

Maybe it's just a font issue ?
Which font did you use on your PC ? Is that same font installed in the Raspberry Pi ?

Hello,

I read you are using QLC+ on RPi through webpage (Web Access). If I remember well, Time widget is not implemented for Web Access.

However, if you connect a display directly on the RPi, the widget should be shown correctly.

Can you confirm this ?

The time displays via the hdmi monitor but time widgets don't work. If I load the same project on an iMac time widgets work but when I load them on the raspberry pi they don't

Can you please share the project ?

Did you try with a new project created on the rpi3 ?

I have attached the project here.

when I say time widgets don't work. I mean scheduled functions don't start, they work when the project is running on my iMac.