Q Light Controller+

Hi everyone. I just was given an Akai APC Mini controller. I want to try it out with a few different software products I use. However, in the past I have had Akai controllers with an editor program that I could set each knob and pad to what I needed it to be. In particular, Toggle vs Momentary.

I am guessing some of you have APC Mini controllers. Is there any way to program the pads for Toggle vs Momentary?

Thanks all,

Rob

Hey Rob,

I've got an APC Mini and here's what I do. I set the button I want in QLC+ to flash,then map the desired button from the APC(I use 'Auto Detect' rather than mapping manuallly). Once this is done you want to click on 'Custom Feedback' and then change the lower value to "1". This means the light on the pad will only be active when the button is held.

Let me know if you have any issues.

Ethan