audio device not working in "service qlcplus" mode
Posted: Fri Dec 22, 2017 7:09 pm
Hello Forum,
I use the latest QLC+ Image for Raspberry (qlcplus_raspbian_jessie_20171028). I get everything running, but i have an issue with my audio input device:
In the Audio Input/Output section all connected sound cards (e.g. USB microphone or USB audio interface) is shown but i can't see any audio level in the configuration area. Also the Audio Trigger in the Virtual Console shows no signal.
I tested around in terminal mode and started QLC+ with the command "qlcplus". Then Audio Trigger is working. When i do the reboot or the "service qlcplus start" command it is still not working.
Does anybody know this issue and can give me some support?
Thanks, Vince
I use the latest QLC+ Image for Raspberry (qlcplus_raspbian_jessie_20171028). I get everything running, but i have an issue with my audio input device:
In the Audio Input/Output section all connected sound cards (e.g. USB microphone or USB audio interface) is shown but i can't see any audio level in the configuration area. Also the Audio Trigger in the Virtual Console shows no signal.
I tested around in terminal mode and started QLC+ with the command "qlcplus". Then Audio Trigger is working. When i do the reboot or the "service qlcplus start" command it is still not working.
Does anybody know this issue and can give me some support?
Thanks, Vince