Q Light Controller+

Hey,

I like using QLC+ a lot. But I do have a question:

I can't use the 2D-View in the monitor with my 4 Spot TBar, because there's only one Spot displayed.
This also affects the useability of the RGB Matrix. Then only the outer Spots are flashing.
How do I get all 4 Spots of the fixture working?

I am using an Eurolite KLS 200. I'm encountering the same problem on my Involight COB Bar 815.

Thanks for the help in advance!

Cheers,
Kevin

Most likely the fixture definition doesn't include heads, or you're using a mode without heads.
What is the manufacturer of 4 Spot TBar ?

As I already mentioned above:

- Euro­lite LED KLS-200 RGB
- Involight COBBAR815 COB LED Matrix-Bar


Cheers,
Kevin

Please try fixture definition for the Eurolite in annex.
I can't find the default Involight definition - so I assume a custom one?