Page 1 of 1

QLC+ auto run show on boot

Posted: Fri Nov 10, 2017 11:28 am
by renderfrog
We intend to have either a windows or a linux version of QLC+ automatically launch a looping show on "power on" of the OS device. - Controlling DMX through a ENTTEC PRO DMX output.

- (OS Hardware power on)
- OS boots
- Start of software
- Load Show
- Play Show
- Endless loop - (Until power is cut)

Which way to best go about this? - We can use either a Raspberry 3+ or a Windows Labtop.

Does QLC+ include the necessary command input to get that far on launch?

Thanks
Torsten

Re: QLC+ auto run show on boot

Posted: Fri Nov 10, 2017 1:10 pm
by mcallegari