Page 1 of 1
EFX Turn Light on
Posted: Tue Oct 10, 2017 7:08 pm
by Scott
First of all I am loving playing with this software. I am currently working with an American DJ Inno Spot Pro moving head light. I am trying to create a chase that goes through scenes and have added a EFX at the end. Unfortunately, when the chase gets to the EFX, it sets channel 11 (shutter) and channel 12 (brightness) to zero. This means that I have a moving head with no light. Is there a way to get around this?
Re: EFX Turn Light on
Posted: Wed Oct 11, 2017 10:14 am
by GGGss
Can you upload your project file please?
I'm guessing in your chase there is something going wrong resetting the ch11 & ch12 values... HTP vs LTP
Official fixture definitions or your own? Please include them in your upload...
Re: EFX Turn Light on
Posted: Wed Oct 11, 2017 3:32 pm
by Scott
GGGss wrote: ↑Wed Oct 11, 2017 10:14 am
Can you upload your project file please?
I'm guessing in your chase there is something going wrong resetting the ch11 & ch12 values... HTP vs LTP
Official fixture definitions or your own? Please include them in your upload...
Thanks for the reply. I figured it out based on your post! I was wrong about the shutter closing but correct about the intensity. I was using the official fixture definitions built into QLC+. Based on your post I checked the setting for Intensity (CH12) and found that it was set to HTP. It was the only one set to HTP so I changed it to LTP and now the EFX function is working properly.
Thanks a ton for your help!