Q Light Controller+

While i will try to write my own fixture file would be great for an expert to also have a go please to see if i get it close to right. thanks all in advance

http://www.ebay.com.au/itm/352024817615 ... EBIDX%3AIT

this is what
i tried to do but it only take up one channel not six
what did i do wrong

thanks again

Looks OK to me.

I added it to a workspace and it shows correctly with an address range of 1 - 6

You can also check your fixtures here: http://www.qlcplus.org/fixture_validator.php

You just need to add the mass and dimensions to the physical characteristics as a final tweak.

thanks for input refined version here

still reporting only sitting on one channel on my system

took the file to PC that runs the lights and it reported it as a 6 channel fixture
set up a simple test show with one light on DMX ch1-6 and it all worked as it should
thanks for all the help - very happy - another step in my QLC+ adventure