Artnet - Arduino
Posted: Sat Jun 03, 2017 6:05 pm
Dear, I set up an arduino, following this detail:
It turns out that in QLC I have a very large delay, and sometimes it seems that the instruction fails ... example: http://blog.deskontrol.net/arduino-base ... tnet-node/
if I raise a channel from 0 to 100% quickly it will light up quickly ... it does not respond ... if it goes down slowly responds...
This just happens with QLC tested with other programs and responds correctly ...
I do not want to change the QLC for another ....: /
Has anyone had this kind of problem?
Thank you.
It turns out that in QLC I have a very large delay, and sometimes it seems that the instruction fails ... example: http://blog.deskontrol.net/arduino-base ... tnet-node/
if I raise a channel from 0 to 100% quickly it will light up quickly ... it does not respond ... if it goes down slowly responds...
This just happens with QLC tested with other programs and responds correctly ...
I do not want to change the QLC for another ....: /
Has anyone had this kind of problem?
Thank you.