Q Light Controller+

Hello I'm new to this Forum and QLC+

I have tried to setup an Audio triggered cue list as described by DJ Drew
but I can't get my list to trigger ie change to the next scene. The list remains stuck.
I notice movement on the EQ of the Audio trigger but no movement of the cue list.
The Chase associated with the cue list works fine when run from the function window and common hold is set to anything other than infinite.

I am using Mac Book El Captian with QLC+ 4.10.5b have also tried it with QLC+ 4.8.5 but no success with either.
Can anyone help

Can you attach your qxw (workspace) file and any custom fixture definitions (.qxf)?

Hi,
Workspace file attached, used with generic RGB definition.
Thanks

janosvitok wrote: ↑Wed May 24, 2017 9:26 am Can you attach your qxw (workspace) file and any custom fixture definitions (.qxf)?

Hi did you make any progress with the audio trigger

I don't see any Cue List nor Audio Trigger in the Virtual Console. Please attach proper file.

Ok thanks for your help.
I've created another workspace please find it attached.

Much better. Did you try to lower the thresholds?
Other than that, it looks ok. I don't see anything wrong.

Yes I've played around with the thresholds, lowered them and increased them.

I don't know what else to do