However, I now start running out of buttons (a commen problem I guess). I could probably add another Launchpad, but would much prefer to have different layout on the launchpad that can be switched. I don´t need to recall more than 64 scenes at once, although there are more in total.
Same thing for the APC40: It has those 2 groups of eight encoders, which I would like to assign to x and y of the eight moving heads they control (single device positioning). Works so far, but I didn´t get to the feedback part yet
. Except for single device control, I would also like to use those faders in a different way, controlling pairs or groups of those moving heads for simple synchronized positioning and moving. Like the buttons mentioned above, this would mean a second layer that maps those encoders to different virtual desk faders (or xy pads in that case). A third layer then would be needed to control scanners in the same way etc. Is there a way to do this within QLC+ ? Is that on the wishlist for 5 ?
If not, one could always try to remap the values externally, but this adds another piece of software and probably more delay than internal mappings. I thought of either Ableton Max4Live or Bome MIDI Translator Pro. Not sure if there are others in that domain.
If those mappings can be switched via MIDI controls themselves, that´d be the icing on the cake.
Is anyone going in the same direction ?
Be careful and do backups because if you do something wrong most probably all of your work is lost.