Q Light Controller+

In the Virtual Console, if I have a group of scenes that change the colour for a particular group of fixtures, like in the attached show file. If I activate the red scene, it works fine, the lights onstage go red. But if without touching the red if I activate the blue scene, the two scenes mix creating magenta onstage.

Is there a way to have it kill the other scenes rather than mix them?

Thanks

Put the buttons in a Solo Frame.

Oh... That was simple.

Thanks for the help.

Take a look to this examples.
http://www.j--a--d.com/QLC+/QLC+%20widgets.htm