Q Light Controller+

Hi there,

With the web API, there doesn't appear to be a way to 'release' or 'reset' a channel so that it goes to 0 or the value set by a function. Is this possible?

This is the API test page:
http://www.qlcplus.org/Test_Web_API.html

Many thanks,
Justin

Can anyone answer this question?
I can set the simple desk channel to 0 via the API, but it doesn't 'clear' the channel and overrides any other functions that might be operating with the same channel

At the moment there isn't a way to "clear" a single channel. There's only a reset button for a whole universe.
The reset-per-channel button has been added relatively recently in QLC+, and it hasn't been ported to the web interface.
I might add it for the next versions.

Thank you for confirming this.
Reset per channel would be a great addition to the web interface and hope it can make the next update. Would be great if this featured on the Simple Desk Keypad as well.
E.g. 1 THRU 10 RESET

Thanks,
Justin

Added on GIT.
As for the keypad, you can customize it on your PC. That's the only self contained page