Q Light Controller+

Hi all,

I use QLC+ on an Pi 3 with no real problems at all. I'm able to get GPIO configured with the GUI on the Pi. but I would really like to edit a show offline on a PC and upload it to the Pi. This works, but I can't edit any GPIO configurations on a PC because they are not there. Any suggestions on how to doe this? I'm now copying and pasting parts of the show XML file but that is not a good way to do it.

Regards,

Remco

Hi Remco,
i am doing the same. As long as you do not have the GPIO plugin installed on your PC (dont know if thats possible) copying the InputOutputMap of the raspberrys configured autostart project is the only way at the moment. In my opinion its a very easy workaround. And by doing this you can use the GPIO plugin on every universe. If you create the config on the raspberry it seems that the GPIO config is only saved on universe 1.

Regards
falken