Q Light Controller+

Hello, I'm using a NanoKontrol2 and is working well, congratulations! This greatly facilitates the work.
The only difficulty that could not solve even searching the forum is how to keep the LEDs connected during operation.
If I assign a controller button to a button QLight it is only active in QLight and not the parent company.

It is possible to solve this? How to make?

Take a look at this post.
viewtopic.php?f=5&t=7638&p=32417&hilit= ... nal#p32417

hank you for your help.

The buttons are beginning to respond properly.

Only the S button controller that behaves strangely.
When tightening S light all 8 buttons ...
They are correctly configured and each directed to a single button.

You know how to solve it?

Hi,

Please share the workspace file (.qxw) here so we can know exactly what you've done.

Solved, thank you!
It was only disconnect and connect it again.