Q Light Controller+

Hi, I can't seem to find any other topics on this on the forum...

Is there any way the plugin settings on QLC+ on the Pi can be changed from a PC?

In order to send sACN to an Avolites console, its IP address needs to be entered into the E1.31 config, and having to use a separate screen, mouse and keyboard is a little awkward.

Am I missing something?

Thanks

Shouldn't this be possible using QLC+'s WebInterface?


Other possibility, open your QLC+ Project on the PC, adjust your settings, copy the file to they Pi and load it. Should work fine.

Baer wrote:Shouldn't this be possible using QLC+'s WebInterface?


Other possibility, open your QLC+ Project on the PC, adjust your settings, copy the file to they Pi and load it. Should work fine.

Thanks, but I can't find an obvious way via the web interface?

As far as I remember, uploading a show file to the Pi wouldn't work because the E1.31 devices have a different name on each device, because of the different IP addresses.

I haven't worked with the E3.31 plugin, so I am not really used to.

If it is really not possible to configure the plugin via webinterface this would be really sad and should be worth a feature request.

Other idea: would it be possible to forward X via SSH, connect to the pi and start qlc+ remotly an see the GUI on your host machine?

Plugins information are stored in the qxw file.
Configure E1.31 like if you were on the RPi, then load the file via web interface

And no, it is not possible to configure plugins via web. Only select them.
If you need specific (one time) configurations, just connect a TV and do them manually

Thanks Massimo,

It's easier to just change the IP on the receiving console now.