Configure so as to prevent accidental double trigger.

[clhuggins]

Hey everyone,

We’re using QLC+ for our church, and I’ve tried to simplify for our volunteers as much as I can.

However, we are constantly plagued with users clicking the active scene again and all the lights going off.

I haven’t seen a preference to change the button behavior from “toggle” to “set”, that might not be a possibility.

Does anyone have any combination of virtual console settings that would possibly prevent this accidental blackout when the same scene is selected twice.

[clhuggins]

I’m going to start looking into the scripting.

Would it be possible to, when pressing a virtual console button, cue a script to check if the scene is currently active? Then, if not toggle that scene.

[GGGss]

Both topics would be feature requests. A 'set and forget' behaviour is often requested. The same goes for a 'default' button inside a solo frame: if everything else is disabled, this default becomes active.
The scripting engine is unaware of what is running, so there is also a 'no' answer.