Need Help with Fixture Editor for JB Systems Plano LED 6in1 - 9 Channel Mode

[lucasb2000]

Hello everyone,

I'm reaching out for some help with setting up the JB Systems Plano LED 6 in 1 fixture in the Fixture Editor. We've been trying to configure it in the 9-channel mode, but it seems we've made some mistakes along the way. We've attached all the relevant documents and screenshots, including the errors highlighted by the Fixture Validator.

Could someone guide us on how to correct these issues? We're particularly stuck on understanding what went wrong and how to properly configure the fixture.

Any assistance would be greatly appreciated!

Thank you in advance for your help!

Lucas

[MichelSliepenbeek]

"Cannot act on itself" -> remove all the Acts On's.
Furthermore your fixture will not show up in 2D Monitor if you do not enter the dimensions (in other words: it will show up as 0 x 0 x 0, so to small to notice).

Your result should look like this.

JB-Systems-LED-PLANO-6-IN-TO-1.qxf

(2.6 KiB) Downloaded 30 times

[lucasb2000]

Thanks a lot to help me out! I works now perfectly!
But maybe stupid question, if I go to sample desk everything works like it should but if I make a scene and place it on virtual console.
THe scene is not showing or activiated. Can some help me with this?

or should i post a separate post for this?

Kind regards


Lucas

[GGGss]

You'd better start a new thread...

But quick answer: make sure there are no red 'X's on your simple desk. Simple desk has the utmost priority and will override everything else...