Good morning,
I use on universe 2 the artnet output at address 127.0.0.1 to send dmx commands to the HEAVYM software. When I run the show cd 02 with version 4.12.7 the dmx values are well supplied and HEAVYM works correctly but when I run this same project on version 4.13.1, the channels are not supplied. Checked with the traditional console tab.
Thank you for your help
Pc windows 11
attached test file
no dmx value sent to univers 2 artnet
-
thibaultphil
- Posts: 52
- Joined: Wed Nov 04, 2015 10:22 am
- Location: Blois - France
- Real Name: philippe thibault
- Attachments
-
test.qxw- show cd 02
- (19.72 KiB) Downloaded 56 times
-
mcallegari
- Posts: 4753
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
Please check the transmission mode. See 4.13.0 changelog.
-
thibaultphil
- Posts: 52
- Joined: Wed Nov 04, 2015 10:22 am
- Location: Blois - France
- Real Name: philippe thibault
Thank you Massimo for your quick response and above all for all your work.
Your solution (switched to artnet in full transmission mode) solved my problem on the reduced TEST project but not on my working project. attached my working project: show to be executed cd 02. The zoom channel does not go up on the 2nd sequence.The zoom channel increases well when I launch the sequences sequentially.
Your solution (switched to artnet in full transmission mode) solved my problem on the reduced TEST project but not on my working project. attached my working project: show to be executed cd 02. The zoom channel does not go up on the 2nd sequence.The zoom channel increases well when I launch the sequences sequentially.
- Attachments
-
- jlb2024 v1.qxw
- (83.21 KiB) Downloaded 47 times