Flash scene with fade out > 0 causes scene to go dark

[Jimmy T.]

QLC 4.13.1

I read a lot about the flash fade issues, but I don't know if it is exactly the behavior I seen.

1. Create simple scene 1+ fixtures.
2. create scene for flash (all white)
a. set fade out to 500ms
3. Create buttons for each scene and mark Flash.

Start show and select scene to be set. Press Flash button and flash shows, but when released it follows the fade out value of the flash scene and when at 0 it does not go back. It should do a cross fade back to where it was.

NOTE: If you use speed dial on your virtual desk to control fade and this scene is part of that list it will be modified and stop working again.

[hukt]

I am having this exact same issue, trying to create a bump that fades out like a halogen would. I'm finding that I have to reload my save file to get it to release those DMX values afterwards, they are locked at 0.

Version 4.13.1 on Ubuntu Studio 24.04