eDrums triggering lights velocity sensitve

[mprinz]

Hi guys,

I need a final hint to get my LED PARs triggered velocity sensitive by the edrum MIDI messages.

So, can trigger them in button mode. Working fine. Some scences in a soloframe + kick and other drums as buttons outside of that frame.

Today I learned, to get a velocity sensitive triggering together with fading I have to use a frame with a fader in submaster mode plus any function.
But I didn't get it. What is the exact config to trigger a LED PAR chaser (with fade, I like this kind of after glow effect when hitting) but velocity sensitive.

Thanks a lot for a short comment, mates!

I only got to threads with "edrums" and a few with "drums" and/or "velocity"?
That's strange. I love blinking lights!

[GGGss]

velocity sensitive

Sensitive means adoptable, adoptable means setting the fade-out time. Setting a fade out time dynamically is done by the Speed Dial widget.
So what if you create a slider on your VC and add the midi input to that ... does this slider react on velocity messages? If so, then a little Loopback Magic could set the Speed Dial and this would influence the fade-out time of a function.
But now I'm a little worried that all will come in time. Setting a fade-time after a function is called ... I'm not sure it will respect the changed time when the function is released again.

[mprinz]

No, sorry!
adoptable in my case is intensity. So, hitting the snare hard -> bright light and subtle hit -> dimmed light.

[Yestalgia]

Perhaps a submaster linked to velocity?

[mprinz]

Dude, that's what I did.

It's submaster linked to a note an/off message + velocity in a frame with an on/off button with the corresponding function.