Hello All,
Having issues with a chain of two generic RGB par lights https://www.amazon.com/gp/product/B07D778PLC.
I can control each light fine on their own (while connected together in a chain) but when I try to send a single to both at the same time the first one starts flashing.
I tried changing cables, adding a terminator at the end, no luck.
Any Ideas?
Thanks for the help,
Ozro
Flickering Issue
-
superozro
- Posts: 2
- Joined: Sat Jan 21, 2023 7:06 pm
- Real Name: ABCDE
Looks like the channel has something to do with the issue, perhaps the manufacturer has extra channels not listed in the manual. I increased the address seperation by 20 and the issue went away. Guess an FYI~ for anyone else having a similar issue.
-
sandinak
- Posts: 191
- Joined: Mon Apr 03, 2017 5:40 pm
- Location: Yorktown, VA
- Real Name: Branson Matheson
- Contact:
So i'd check:
- the fixture definition against the manual and make sure all the channels are defined in the definition. Sometimes people miss things.
- you are using the right "mode" defined for the fixture, and the fixture is also set at the right mode ( 9 chan vs 15 ..etc..) this is a common mistake.