OSC feedback issue

[Eliot]

Hello, I have a problem with the OSC feedback.
(Config : Universe 1 Artnet or DMX USB, Universe 2 osc plugin connected to touchOSC on iPad)

In the virtual console, I map my buttons to the osc commands, once everything is set up everything works correctly.
However, when I save my project, close it and reopen it (all my osc settings are still good: ip and ports...) I can still trigger my functions with OSC but the feedback doesn't work anymore.
I run QLC+ 4 in debug mode and this is what I get :

Code: Select all

[OSC] sendFeedBack - Key: "" value: 0
void OSCPacketizer::setupOSCGeneric(QByteArray &, QString &, QString, QByteArray &) Empty path, can't create packet
[OSC] sendFeedBack - Key: "" value: 0
void OSCPacketizer::setupOSCGeneric(QByteArray &, QString &, QString, QByteArray &) Empty path, can't create packet
[OSC] sendFeedBack - Key: "" value: 0
void OSCPacketizer::setupOSCGeneric(QByteArray &, QString &, QString, QByteArray &) Empty path, can't create packet
[OSC] sendFeedBack - Key: "" value: 0
void OSCPacketizer::setupOSCGeneric(QByteArray &, QString &, QString, QByteArray &) Empty path, can't create packet
[OSC] sendFeedBack - Key: "" value: 0
void OSCPacketizer::setupOSCGeneric(QByteArray &, QString &, QString, QByteArray &) Empty path, can't create packet
[OSC] sendFeedBack - Key: "" value: 0
void OSCPacketizer::setupOSCGeneric(QByteArray &, QString &, QString, QByteArray &) Empty path, can't create packet
[OSC] sendFeedBack - Key: "" value: 0
void OSCPacketizer::setupOSCGeneric(QByteArray &, QString &, QString, QByteArray &) Empty path, can't create packet

If I want the feedback to work again, I have to repatch everything (which is a bit long each time ) but in another universe (example 3). It seems that QLC does not save well the route of the feedbacks

Thanks for your help

[mcallegari]

please share workspace and if needed OSC input profile

[Eliot]

Thanks for your quickly answer, with your question, I have understood alone what I was doing wrong.
I haven’t created an input profile, I have just done an auto detect mapping in the dashboard. Now I created a custom input profile and everything works fine.