DMX Input Trigger

[sheventn31]

Hello,

I have a ENTTEC DMX USB PRO Interface - Univers 1 is Output and works fine. Now I want to trigger a Scene via DMX Input
I set Universe 2 as Input and now i don't now how to set the rest to trigger the Scene...
Can anyone help me?

LG

[GGGss]

On VC create a button bound to the scene you would like to trigger.
In the properties of the button, you can assign an external control. Select universe 2 input 1. https://www.qlcplus.org/docs/html_en_EN/vcbutton.html 'external input'
(You can create an input profile if you would like to have a more descriptive name...)

[sheventn31]

I did it as described but it doesn‘t work…..is it possible that the Interface is wrong configured?

[GGGss]

You are using the EntTec Pro interface. With the PRO manager, you have to set a universe as input.
I assumed you already figured that out.
When a signal enters QLC+ you should see a wiggling joystick on the in- output tab, where you set the universes.

[sheventn31]

I can't change the Input on den Pro Manager, only Output Rate, MAB, Break Time.....but now Input or Output
When i look at the DMX Receive Test on the Utility Control - i get the a signal one the right Channels but if i switch on the RaspberryPi i don't get a Signal
i use the ENTTEC DMX USB PRO Interface

[GGGss]

Verify DMX 101:
* Make sure you have 'a signal' -> NO high impedance (=no cable fault, make it as short as possible)

* Verify with the tools you get with the product, that it IS registering something

EntTec Pro MK 2 Pro Manager -> cable channel 1 used as input

*(stop the tool you are using because it 'may' have exclusive access rights to the device)

*in QLC+:
- important: verify that a channel of your interface is NOT selected as input & output

^^ BAD ^^

[GGGss]

-- subsequent post --

^^ GOOD ^^

and ... IT DOESN'T WORK - oke fair enough!

Will try to find a solution ...
I start a new bug-report thread and will update here also.

[sheventn31]

Thank you