Flash scene not turning off all channels
-
mondovibrations
- Posts: 2
- Joined: Sat Sep 25, 2021 3:34 am
- Real Name: Mike ger
I created a scene for my Fog Fury Jett which includes turning on channel 1 (fog) and channel 2 (red). I then created a button on the virtual console for this scene and set it to a flash function. When I am live in operate mode, the button turns channel 1 and 2 to 255 when pressed, but when release, channel 1 stays at 255, and does not go back to 0 as channel 2 does. What could be causing this issue?
-
janosvitok
- Posts: 1325
- Joined: Mon Apr 13, 2015 7:05 am
- Location: Bratislava, Slovakia
- Real Name: Jano Svitok
- Contact:
Channel 1 is LTP?
-
mondovibrations
- Posts: 2
- Joined: Sat Sep 25, 2021 3:34 am
- Real Name: Mike ger
That was it!! Thank you!
Last edited by mondovibrations on Tue Jan 11, 2022 6:24 am, edited 1 time in total.
-
GGGss
- Posts: 3052
- Joined: Mon Sep 12, 2016 7:15 pm
- Location: Belgium
- Real Name: Fredje Gallon
When someone responds: "That was it! Thank you!" one might assume that it was solved. No?
To your problem: What do you mean by 'It happens'? What is 'It'?
To your problem: What do you mean by 'It happens'? What is 'It'?
All electric machines work on smoke... when the smoke escapes... they don't work anymore
-
janosvitok
- Posts: 1325
- Joined: Mon Apr 13, 2015 7:05 am
- Location: Bratislava, Slovakia
- Real Name: Jano Svitok
- Contact:
The key is to understand difference between HTP and LTP (see e.g. https://www.qlcplus.org/docs/html_en_EN ... t.html#LTP).
Then find out if the channel is HTP or LTP (check fixture definition -- all groups except dimmer/intesity are LTP) and/or override it in channel properties https://www.qlcplus.org/docs/html_en_EN ... rties.html