Is it possible to control multiply channels of a fixture independently,
using the buttons from Virtual Console?
P.ex. assuming a 4 Channel RGB par, i have created:
Slider1 - CH1:Density
BTN1 - CH2:Red
BTN2 - CH3:Green
BTN3 - CH4:Blue
Slider1 works ok.
When i press BTN1 i get the Red, ok.
But when i press BTN2, BTN1 goes off, and i get a Green
I cannot have both buttons pressed to get a Red-Green.
(The fixture has independent leds)
I need to create on the fly [color + pattern + movement] combinations without the need to create 100+ buttons.
Hope you understand and makes sense what i am talking about.
