Open icon is disabled

twaga · Wed Jan 20, 2021 4:18 pm

I chose direct access as the way to access my raspberry pi written on section 5.2 in QLC+ RaspberryPi Buster Guide.
I want to open my project made on my windows 10 PC, but the open icon is disabled as indicated in this picture.
https://drive.google.com/file/d/1_akOhX ... sp=sharing
What should I do to open a project created on my windows 10 computer?

questionmark · Wed Jan 20, 2021 4:19 pm

(Looks like your picture didn't get attached.)

sbenejam · Wed Jan 20, 2021 6:07 pm

Press stop button, and then open button turns enabled.

twaga · Thu Jan 21, 2021 9:54 am

I was able to turn the open icon enabled.

Could you tell me the way to confirm Raspberry PI's IP address in order to receive the project file from another computer via SSH?

sbenejam · Thu Jan 21, 2021 1:18 pm

The Input/Output tab shows the IP addresses that are active after boot. FYI take a look to the QLC+ Raspberry Manual this questions are explained there.

twaga · Mon Jan 25, 2021 10:53 am

Thanks to your advice, I was able to successfully load my own project file.

Is renaming the file to autostart.qxw the only way to read this file automatically as soon as QLC+ boots?

GGGss · Tue Jan 26, 2021 9:07 am

As stated in the manual, you can use command switches to open a project when QLC+ starts.