QLC+ 4.12.2 Windows 10
The mousewheel now works as follows:
When the mouse cursor is on a slider/knob using the mouse wheel controls the slider/knob.
When the mouse cursor is not on a slider/knob the mouse wheels scrolls the workspace.
This seems logical, but has some very annoying side effects !
1: When scrolling the workspace and a control scrolls to under the mouse cursor you will unintendedly change the control on the next scroll!
2: When changing a control and the control reaches its end you will unintendedly scroll the workspace!
I suggest to change this behaviour in such a way that you have to click the control before the mouse wheel changes it and than the mouse cursor has to leave the control again before the mouse wheel scrolls the workspace again.
(Note that clicking on the 'scale' still should still set the value immediately!, so you would have to click on the knob itself or anywhere else on the control but not the 'scale')
Q Light Controller+
Official forums of the QLC+ project
Software is the stuff that makes Hardware flexible ! 