New to QLC+ and hoping to use it for some things in a theater. I've setup the house lights so I can run them in a cue list for the start and after intermission of performances. I set scenes for House at full, House at Half, and Black Out. There's an initial 5s fade in to full that would be before doors open and would also be the beginning of intermission as it loops back to beginning. That holds until I advance. Then a double flash that's automated and then it holds until I advance. Then fade to half, and then fade to black.
Now when I run it from a cue list in virtual console it runs as expected according to the monitor. When I advance through the chaser under functions it doesn't quite do the same though. The initial fade up to full has no fade. The House full scene is actually at about 70% or 178. After the flash part of the chase, when I advance from House full to House half, the monitor shows them all go up to the full 255 before fading down to half. I guess since it doesn't do it in virtual console it's not that big of a deal but I would really like to know what is going on.
Q Light Controller+
Official forums of the QLC+ project
