Configuring the Network
-
ashishalexander
- Posts: 1
- Joined: Mon Jul 08, 2019 10:12 am
- Real Name: Ashish
Hey guys. i am relatively new to the lighting world. I have a Lightech Artnet to DMx 2 controller. It is connected to my PC via ethernet directly. I am trying to control my LED PAR Cans using the software. I have managed to get the device detected but there is no output. I have attached some preview photos. I am using artnetominator to monitor the output. I Can see that there is signal output.
-
sbenejam
- Posts: 607
- Joined: Sun Apr 12, 2015 6:28 pm
- Real Name: Santiago Benejam Torres
- Contact:
Can you post more details of your setup, OS, QLC+ version, your network configuration, a sample project file, ...?.ashishalexander wrote: ↑Mon Jul 08, 2019 10:34 am Hey guys. i am relatively new to the lighting world. I have a Lightech Artnet to DMx 2 controller. It is connected to my PC via ethernet directly. I am trying to control my LED PAR Cans using the software. I have managed to get the device detected but there is no output. I have attached some preview photos. I am using artnetominator to monitor the output. I Can see that there is signal output.