Hello,
since last week, I have QLC+ 4.12.1. It is a very nice Software for DMX controlling.I have two lightmaXX EASY WASH TRI. When I want to create an Effect with the first one, it works. But when I want to create an Effect with the second one the first one go ape. He changes the colors and make himself. I can't control him.
What can I do?
Many Greetings.
Moving Head makes what he want
-
GGGss
- Posts: 3052
- Joined: Mon Sep 12, 2016 7:15 pm
- Location: Belgium
- Real Name: Fredje Gallon
What interface do you use?
It might be necessary to lower it's output frequency. There a quit some post about that here...
It might be necessary to lower it's output frequency. There a quit some post about that here...
All electric machines work on smoke... when the smoke escapes... they don't work anymore
-
GGGss
- Posts: 3052
- Joined: Mon Sep 12, 2016 7:15 pm
- Location: Belgium
- Real Name: Fredje Gallon
Rereading your first post - I noticed a potential problem:
Did you use a correct DMX address for both of them?
If addresses would overlap - controlling #2 would influence #1.
Did you use a correct DMX address for both of them?
If addresses would overlap - controlling #2 would influence #1.
All electric machines work on smoke... when the smoke escapes... they don't work anymore
-
GGGss
- Posts: 3052
- Joined: Mon Sep 12, 2016 7:15 pm
- Location: Belgium
- Real Name: Fredje Gallon
Can you make a little video of what is going on?
The definition: 'it doesn't work' is so vague - you might think: Is the powercord connected?
The definition: 'it doesn't work' is so vague - you might think: Is the powercord connected?
All electric machines work on smoke... when the smoke escapes... they don't work anymore
-
yokosuna
- Posts: 204
- Joined: Tue Mar 22, 2016 9:07 am
- Real Name:
What happens when you switch adresse and/or position of the MH in the chain ?
Are both usinf the same "mode" (4CH, 12CH) ?
If everything is programmed correctly, I second that there is a electrical problem.
Have you ever tried using a terminator ? Chinese products tend - from time to time - to
be not assembled the way they should be...
Are both usinf the same "mode" (4CH, 12CH) ?
If everything is programmed correctly, I second that there is a electrical problem.
Have you ever tried using a terminator ? Chinese products tend - from time to time - to
be not assembled the way they should be...