Help... No Artnet being sent...
-
chegelheimer
- Posts: 1
- Joined: Tue Apr 02, 2019 1:23 am
- Real Name: Charlie
Hey guys! I am totally new to this software. I am merely using it to interpret MIDI from a device I have that I would like to use along with a Grand MA Lite console for a show this weekend. I have been going in circles trying to figure this out. I do not think the software is actually sending any Artnet data out of the IP selected as shown in the information box and cannot figure out why. Im assuming this is a really simple thing that I am just over looking. Any help would be greatly appreciated
- Attachments
-
-
-
mcallegari
- Posts: 4712
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
[moderator] Moved to usage questions.
Have you tried with Wireshark and see if packets are sent?
Have you tried with Wireshark and see if packets are sent?
-
GGGss
- Posts: 3052
- Joined: Mon Sep 12, 2016 7:15 pm
- Location: Belgium
- Real Name: Fredje Gallon
Artnet in former days had to be in the 2.x.y.z mask 255.0.0.0 or 10.x.y.z range.
and choose to send in unicast (now you can enter the Artnet destination Ip-address) - I cannot see this information in your screenshots.
and are you sure the grandMA is in Artnet mode and not session mode?
(Do you use an intelligent switch? Disable storm control on both ports (QLC+ and GMA))
and choose to send in unicast (now you can enter the Artnet destination Ip-address) - I cannot see this information in your screenshots.
and are you sure the grandMA is in Artnet mode and not session mode?
(Do you use an intelligent switch? Disable storm control on both ports (QLC+ and GMA))
All electric machines work on smoke... when the smoke escapes... they don't work anymore