Click and Go

Ask a generic question about the usage of QLC+, not related to a particular operating system
Post Reply
Drunkendrummer
Posts: 8
Joined: Sat Feb 23, 2019 7:34 am
Real Name: Mark Cooper

Hi

I am getting myself very confused about click and go! I want to have a colour picker for an RGB fixture but I can't work out how to get it to work (using simple desk) bit there is nothing obvious here - the information I have found says it is already enabled in this. I looked in the fixture definition editor (the info says it starts here) but can't see anything about how to add it there either. I can add a colour wheel or macro, but that's obviously not right. Unfortunately there is not a lot in the manual about setting it up.

Any advice would be welcome.

Many thanks
User avatar
edogawa
Posts: 630
Joined: Thu May 07, 2015 10:34 am
Real Name: Edgar Aichinger

As far as I understand, there's no RGB Click&Go in Simple desk. Right clicking a fader gives single colour Click&Go intensity bars and tables depending on the channel capabilities, so this part is there.

In VC, when editing slider properties, in level mode you can enable Click&Go, select the fixtures' R,G,B channels (or CMY, Gobo etc.) and corresponding Click&Go mode, and it will show the colour picker/Gobo selector etc.

Hope that helps
User avatar
mcallegari
Posts: 4712
Joined: Sun Apr 12, 2015 9:09 am
Location: Italy
Real Name: Massimo Callegari
Contact:

Resources are:
https://www.qlcplus.org/clickandgo.html
and
https://www.qlcplus.org/docs/html_en_EN ... l#channels

Then you can use Click & Go with Virtual console sliders in level mode
Drunkendrummer
Posts: 8
Joined: Sat Feb 23, 2019 7:34 am
Real Name: Mark Cooper

Thanks for the prompt reply. I did read the documentation on click and go, bit found it hard to follow I'm afraid. As it said click and go is automatically enabled in simple desk, I assumed it could control the colour of colour of the RGB channels. I will give the virtual console a go.
User avatar
mcallegari
Posts: 4712
Joined: Sun Apr 12, 2015 9:09 am
Location: Italy
Real Name: Massimo Callegari
Contact:

By "Click & Go is enabled by default on Simple Desk and Scene's sliders" I meant what you see in the screenshot.
Just click on the channel icon to display a Click & Go popup. Doesn't seem that hard to me.
Attachments
Screenshot_20190319_140850.png
Post Reply