QLC+ 5.0.0 Alpha 3 and SGM Victory II 250 scanner

[marcotasto]

Hi,
I'm trying QLC+5 for the very first time and I've noted something I'm not able to understand.
Started a very simple workspace, with only a single SGM Victory II 250, Mode2. In 3D view mode the scan is positioned at center stage, rotated with mirror on top (X at -90deg and Z at +180 deg).
After turning on the lamp, in 3D view the beam is projected at the opposite side I would expect to have (i.e. to the floor).
Seems that the zero position is not reflecting the real position we have in the physical fixture. This is consistent when the mirror is moved through the pan/tilt widget. What I'm missing?
Also, as far as I can understand it's no yet possible to handle the reverse pan and reverse tilt settings on the real unit. Is it correct?

Thank you.
Marco.

[mcallegari]

Hi, I haven't tested scanners very much yet. I think I've already seen what you've seen and I will fix it.
As for reverse pan/tilt, correct, it's not handled yet.

[marcotasto]

Thank you, Massimo.
I've three of this scanner and I can check the matching between virtual and physical.

Thank you and best regards,
Marco.