When I edit a button I can't save changes. Can I change setting so I can use this screen?
Screen: 7"
Official Raspberry Pi 7" touchscreen
-
de DJ Fabriek
- Posts: 64
- Joined: Fri May 22, 2015 9:07 am
- Real Name: Tiago Vilhena de Oliveira
- Attachments
-
-
mcallegari
- Posts: 4807
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
That dialog is too large for a 7" screen.
I don't really understand why you guys insist on using the Raspberry Pi for project editing.
Can't you just do it on a PC with a larger screen and use the Pi only with the virtual console ?
I don't really understand why you guys insist on using the Raspberry Pi for project editing.
Can't you just do it on a PC with a larger screen and use the Pi only with the virtual console ?
-
de DJ Fabriek
- Posts: 64
- Joined: Fri May 22, 2015 9:07 am
- Real Name: Tiago Vilhena de Oliveira
You are certainly right. If it could have done then it is easy to make small adjustments immediately without a computer.
Thank you for your quick response.
The black border I have try to resolved.
I already tried to solve the black border, but I did not succeed. Is there a solution for this?
Thank you for your quick response.
The black border I have try to resolved.
I already tried to solve the black border, but I did not succeed. Is there a solution for this?
-
mcallegari
- Posts: 4807
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
Most likely you need to remove the --overscan parameter from /etc/init.d/qlcplus
-
de DJ Fabriek
- Posts: 64
- Joined: Fri May 22, 2015 9:07 am
- Real Name: Tiago Vilhena de Oliveira
Thanks !mcallegari wrote: ↑Tue Nov 06, 2018 6:14 pm Most likely you need to remove the --overscan parameter from /etc/init.d/qlcplus