Hello dear community,
I have a short question, is it possible to use 4 RGB Led lamps as an volume indicator.
I want to use two for the left and two for the right audio channel and the volume should just control the intensity of one color, so that if the audio(l+r) is at 50% just one for left and one for right should be on 100% intensity and the over two should be off, at 100% audiol+r) all lamps should be at 100% intensity...
I am new to Qlc+ and want to use this effect in about 4 days so a fast response would be great.
Thank you in advance
LED Matrix as volume indicator
-
siegmund
- Posts: 703
- Joined: Mon Nov 02, 2015 11:03 am
- Location: Germany
- Real Name: Lukas
Hey, welcome to the forum!
This could possibly work. You'll need to have a look at the audio trigger widget. Also, you need to separate the audio channels outside of QLC+ and create one audio trigger for each channel.
Another side note: Might be difficult to define "100% audio"...
Lukas
This could possibly work. You'll need to have a look at the audio trigger widget. Also, you need to separate the audio channels outside of QLC+ and create one audio trigger for each channel.
Another side note: Might be difficult to define "100% audio"...
Lukas
-
mcallegari
- Posts: 4720
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
Hi, there's a preset called "Audio spectrum" in the RGB Matrix preset list.
Try and play with it. You might need to set the speed to a quite low value (e.g. 100ms)
Try and play with it. You might need to set the speed to a quite low value (e.g. 100ms)