Hi
I have just installed version 20180410 (4.11.2) on raspberrian stretch.
I get the following error when running qlcplus:
Could not create the egl surface: error = 0x300b
Aborted
Any suggestions?
Could not create the egl surface: error
-
mcallegari
- Posts: 4807
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
Hi, are you using my image or installed the deb package on a vanilla Stretch ?
this might interest you: http://www.qlcplus.org/forum/viewtopic.php?f=17&t=12122
this might interest you: http://www.qlcplus.org/forum/viewtopic.php?f=17&t=12122
-
Yarjm
- Posts: 3
- Joined: Fri Jun 22, 2018 1:45 am
- Real Name: Ray Moxham
Hi mcallegari
The deb package.
I checked the manual installation from a previous version and made sure all the libraries it required were installed. I can't see any missing.
If this is part of the problem with the graphics driver then I will wait patiently and see what happens. I can use the image in the meantime. It is just handy to edit fixtures on the same box.
I love the program by the way.
Ray
The deb package.
I checked the manual installation from a previous version and made sure all the libraries it required were installed. I can't see any missing.
If this is part of the problem with the graphics driver then I will wait patiently and see what happens. I can use the image in the meantime. It is just handy to edit fixtures on the same box.
I love the program by the way.
Ray