The creation of fixtures. White and blue mixed up?

[vormy]

Hi. There is a small problem. Created a fixture for the device. Further in the project I noticed that the white and blue colors are mixed up and the display of the visualization does not correspond. If the editor fixture swap places then everything becomes correct, but it is inconvenient to create projects so there is confusion.

[siegmund]

Please post your project and, most importantly, the fixture definition.

[vormy]

It turns out that the fixture create the manual to the device. And the program is mixed up.

[GGGss]

Please use English inside fixture definitions

Here is your problem

Cap_ 2018-06-05 15.37-237.png (7.21 KiB) Viewed 333 times

You didn't use the right order

Cap_ 2018-06-05 15.39-238.png (10.54 KiB) Viewed 333 times

Since I cannot verify other settings (language) I didn't change the file.

[vormy]

I create the device as in the instructions.
But the program is somehow mixed white and blue.
In the program, I adjust the 4 channel, in the program it is marked as white but the blue channel is regulated on the device as in the fixture. But the problem is in the 2D monitor displays colors incorrectly.

The problem can be solved by swapping the white and red when creating a fixture, then the program will display correctly.

[vormy]

Excuse me. Really in modes I made a mistake