Issue: closing QLC+ in dirty state = no warning

[GGGss]

Massimo,

Excuse me if I'm regression testing the new alpha ... I'm just documenting all I come across - hope you understand my willingness to add my contribution to this marvelous project

win10 alpha 2

. add 1 dimmer to a clean project
. close QLC+

ISSUE: in this very basic scenario you can close QLC+ in a dirty-state without warning to save

(While debugging I make sure I close and reopen QLCplus-qml over and over again to create a one off situation)

[mcallegari]

Thanks, tracked here: https://github.com/mcallegari/qlcplus/issues/1047

[GGGss]

Before investigating further...

I ONLY added a fixture ... NOTHING more
(In the meantime looking at the interface I see the little disk symbol appearing at whatever I do ... at 95% of time so it IS oke - except empty project + add fixture(s))

My guess: - adding fixture does not set 'dirty'-bit

[GGGss]

As an exercise:
I redid your youtube post "QLC+ 5 Preview - Update #3.2" until 3:25

simply pressed [ALT] + [F4]
and QLC+5 did NOT pose the 'wanne save'-question and did close in a dirty state