mid trigger to change shows.

[wayneward]

Ive got qlc set up nicely and operating all my fixtures with no glitches!

i have connected using midi as ive noticed a small joystick coming up when im send triggers from my show player.

what i need to find out is what are the controls for it to pick a show and the control to start that show

so my show player will play say here comes the sun and send a midi trigger to pick here comes the sun light show and then make that play.
at the end of the song move to a static light show and then when i start the next song it will change the program for that song and then play the show.

is there a list of commands or can somebody just tell me the midi command to select show and play show.

i might not need the play command just pick show scene im thinking if you can tell me how to do this.

[siegmund]

You may assign your shows to buttons in the virtual console and trigger them with any MIDI command you like (define this MIDI command in the button's preferences of course).

[wayneward]

I just figured it out about ten minutes before you sent this message!! Yes this works thankyou so much..
Ill leave this open for a day or so incase i run into any problems during me implenting this action.

[DiDi]

I'll select Shows by a Midi Program-Change. With a Controller (z.B. CC1 or CC2) it works.
But if i send one Program-Change to QLC the Program-Change and the follow Commands dont have an effect.
A Midi-Program-Change is only a 2-byte-Message (see https://www.midi.org/specifications/ite ... di-message ). Can it be that the Midi-Input of QLC only can work with 3-Byte-Messages?

[DiDi]

Ok. Sorry. It's not a Bug. I've set the MidiMode form the Inputchanel to Programchange - and ist works very fine.