We have some house lights set up in the followng manner:
16 x Monoprice PAR38, all on channel 1
16 x Lixada PAR64, all on channel 26
(And various other stage/wall fixtures on individual channels without overlap)
This works well from a control standpoint, but we're trying to figure out how to get monitor configured to display all the physical fixtures we have that overlap channels. I can only figure out how to get one to show, even editing the XML and adding new entries for the same fixture in <monitor> and also by adding duplicate fixtures with new <id> tags.
QLC+ is too smart and fixes the "obvious mistake" I must have made
How do I get around the hard-line limit so that I can display everything on the monitor page?
We would definitely prefer not having to change all the lights to not overlap since we're dealing with trusses 20ft/6m high