I don’t see any USB connection options in the Input/Output section of QLCPlus interface. I see Artnet, GPIO, etc. am I missing something? I’m using an Entyec DMX Pro.
Thanks!
Enttec DMX
-
mcallegari
- Posts: 4807
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
GOIO ? Kissing something ? Entyec ?
Can you please read your post again before posting ?
What does the 'dmesg' command say when you plug the interface ?
Are you sure you're using a proper power adapter and/or USB hub to provide enough current to the DMX interface ?
Can you please read your post again before posting ?
What does the 'dmesg' command say when you plug the interface ?
Are you sure you're using a proper power adapter and/or USB hub to provide enough current to the DMX interface ?
-
djtommye
- Posts: 5
- Joined: Fri Nov 24, 2017 5:36 pm
- Real Name: Tommy Evans
Sorry about the spelling...
Interesting. dmesg would show the EntTec, then list errors reading it ("device descriptor read/64, error -32") . I have a second (older) EntTec DMX USB Pro laying on my desk, and I connected that, rebooted, and now it shows up.
Thanks for pointing me in that direction...
Interesting. dmesg would show the EntTec, then list errors reading it ("device descriptor read/64, error -32") . I have a second (older) EntTec DMX USB Pro laying on my desk, and I connected that, rebooted, and now it shows up.
Thanks for pointing me in that direction...