XY PAD new features are crashing qlcplus

[tolmino]

Hi,
i have installed and tested new features in XYpad

i have a crash when in XY pad i add a scene button.

if i add a simple XY position all works right..... the crash happens only when i click on scene button.

I attach a test qxw file

thanks in advance.

[mcallegari]

Fixed on GIT.
Silly mistake in the code.

Thanks for reporting !

[tolmino]

Massimo, now scene are working, but XY positions not.

and i notice that when i'm using an EFX, i don't see the circle moving into the xy pad area.

[mcallegari]

Massimo, now scene are working, but XY positions not.

and i notice that when i'm using an EFX, i don't see the circle moving into the xy pad area.

What do you mean ? Please elaborate.
I've done the tests with the DMX monitor, and as far as I can tell absolute positions, EFX and Scenes+Relative are doing their job.

[tolmino]

and in every case it is not crashing

[tolmino]

if i go into proprieties of XYpad into presets tab
i can move blue ball into a position and store it.... but lights are not moving

i can store the position i have touch, and so i can have a button with x and y position set
but if i call that position, lights don't move.


if i call scene, light move right
but i don't have feedback into xy pad

[mcallegari]

if i go into proprieties of XYpad into presets tab
i can move blue ball into a position and store it.... but lights are not moving

Yes, they don't move. This is known.

i can store the position i have touch, and so i can have a button with x and y position set
but if i call that position, lights don't move.

Have you assigned a list of fixtures in the XY Pad ? Otherwise, it's obvious nothing will move...

if i call scene, light move right
but i don't have feedback into xy pad

What do you mean ?
If you read the updated documentation, you will see that the when calling a Scene preset, the XY Pad goes in relative mode, so the cursor will move to the center of the XY Pad and from that position you can control relative offsets.

[mcallegari]

if i go into proprieties of XYpad into presets tab
i can move blue ball into a position and store it.... but lights are not moving

Fixed on GIT. Pull the change and try again

[tolmino]

ok
now lights are moving rights!

feedback is not present as older versions, but is not a problem

thanks Massimo !!