[SOLVED] Raspi 2 with Original Massimo-Image and iPad 4 with Touch OSC - no connection

[Chorum]

Hello guys,
I use a Raspi 2 with QLCplus on a 8 GB SD-Card (Original Massimo-Image) and it work Fine. Now I try to control it via an iPad and Touch OSC. When I try the setup on a Desktopcomputer it work well and i receive OSC-messages from the iPad. But when I try the same Setup on the Raspi it won't work. Any known issues on that?
I have configured an old FRITZ!Box as an Accesspoint and connected it per Lan-Cable with the Raspi. In this configuration I can access the QLCplus-Webinterface on the Raspi from the iPad with Chrome-Browser, but, just I said, I don't receive any OSC-Messages...

Please, can anyone help me to solve this Problem?
Thank you very much for hints and suggestions of all kind.

[mcallegari]

Hi, are you sure you're not using the loopback device on the RPi ?

Read the 4.9.0 changelog. It's written there to update your project IO configuration

[Chorum]

Webinterface via iPad

Webinterface via iPad

Trank you for the fast answer on my post!
Yes, I'm sure I don't use the loopback device...

[mcallegari]

Uhm...maybe what's wrong is that you change both the input and output parameters.

As written here: http://www.qlcplus.org/docs/oscplugin.html

Note: When patching a Input+Feedback line, the output IP/port you need to change are the ones in the 'Inputs' section. Just leave the 'Outputs' section as default.

Please try that. Also, please let me know if you see a joystick displayed in the corresponding universe when you send data from the iPad.

[Chorum]

Thank you for the hint! Reset the ports as discribed in the OSC-manual did the work, now I receive osc-messages and See also the little Joystick when I use Touch osc on my iPad. Thank you very much for the Support and the lots of work to bring qlc+ to the Raspi.

Best regards
Chorum