Dear Friends,
I'm new to QLC+ and switching over from Enttec DMXIs / Show Buddy. Is there a way to trigger a show via MIDI? I have setup a profile and have QLC+ and can get it to hear MIDI from another program. I can get the button to start the show in Virtual Console, but I can't seem to trigger the button (in VC) via MIDI. Is this my lack of knowledge or a limitation of the program? Thank you for your time.
peace,
mjm
MIDI show question
-
mcallegari
- Posts: 4826
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
Yes there is.michaeljamesmette wrote:Is there a way to trigger a show via MIDI?
What happens when you do "Auto Detect" in the button config page ? Does it receive the MIDI signal ?michaeljamesmette wrote:I have setup a profile and have QLC+ and can get it to hear MIDI from another program. I can get the button to start the show in Virtual Console, but I can't seem to trigger the button (in VC) via MIDI. Is this my lack of knowledge or a limitation of the program?
Did you check the MIDI channel you use in the sending software (which is ?) is the same used by QLC+ ?
-
michaeljamesmette
- Posts: 3
- Joined: Mon Jun 22, 2015 11:46 am
- Real Name: Michael James Mette
I could get QLC+ to receive the MIDI message, but I was having a problem getting the virtual console to see it. I could see it in the Input / Output section, but could not get it to work in the virtual console. I tried downloading version 4.8.5 as well as the latest 4.9.0 I'm sure there's some setting that I'm missing. I may just wait until version 5.0 to switch over. Thanks for all of your hard work!
peace,
mjm
peace,
mjm